For Boats & PWC

"Your product is outstanding. Recently I purchased a model 102 for my Father-in-laws' 20' Boston Whaler. Now I want to order one to install on my own."
Peter C. Miami, FL - KeelGuard Customer

"Installation was a breeze, I actually put it on in the parking lot of a casino in Laughlin NV. We sure like it and look at it as a small insurance policy on our investment."
Michael M. Glendale, CA.- KeelGuard Customer

Read more testimonials here

• Protect against abrasive sand, rocks, concrete ramps and oyster beds
• Eliminate costly repairs
• Enjoy the highest quality and superior engineering
• Increase the value of your boat

Wear and damage to your boat’s keel can break down its protective gelcoat finish, allowing water to reach and destroy the fiberglass laminates.

The Keel Guard is a very simple product to install; however, the following instructions must be strictly followed. Any short cuts or missed steps will jeopardize and compromise the full bonding capabilities of the 3M adhesive. For best results the KeelGuard should be installed at an ambient temperature of 60º or above.

Typically, the Keel Guard is mounted 4 to 6 inches above the waterline on the bow, ending 2 to 3 feet or more beyond the lowest point of the Keel. For personal watercraft, begin the KeelGuard approximately 1 inch below the bow hook, running the length of the keel, and ending 4 to 6 inches forward of the pump intake.